Tandy 1000 MS-DOS Reference Manual page 368

Appendix D / Hard Disk Setup
4. Copy all the files from your MS-DOS system diskette to
your hard disk drive. If you are setting up only one hard
disk partition, this is the final step.
5. Use the MLPART command (MLPART.COM) to create one
or more non-bootable, DOS2 partitions on your hard disk.
6. Copy MLPART.SYS from the Supplemental Programs
diskette to your hard disk drive. (Be sure to include a
DEVICE
=
MLPART.SYS command in your hard disk's
CQNFIG.SYS file.)
7. Reboot the computer from the hard disk drive to install the
MLPART.SYS device driver (load it into memory).
8. Use MLFORMAT to format any DOS2 partitions you cre-
ated. (This is an optional step. Do this only if you use
MLPART to create one or more DOS2 partitions.)
344
.
'
~
I •
I •
L......J