Tandy 1000 MS-DOS Reference Manual page 319

r
I
r
r
! '
,........,
I :
n
I
,........,
! '
11
, l
,..,
I
I
, I
Chapter 14/ Problems and Error Messages
Command Error Messages
The following errors can occur while using MS-DOS commands.
Acce55 denied
You tried to replace or copy to a write-protected, read-only, or
locked file.
After format, one of 5Y5tem 5ector5 could not be
read
Errors were found on the system sectors of the disk. The disk
might be unusable.
All file5 canceled by operator
This is a reminder only. You used the IT parameter with PRINT
to cancel the printing of all files in the print queue.
Allocatlon error, 51ze adju5ted
A filename is displayed with this message. The File Allocation
Table (FAT) contains an invalid sector number. CHKDSK auto-
matically truncates the file at the end of the last valid sector
number.
Bad command or file name
The command you typed is not valid. Check spelling and reenter
the command. If the command is an external command, be sure
it is in the directory that MS-DOS is searching for commands. If
you are trying to execute a batch file, be sure you are in the
directory which contains that file.
Bad or mi55ing Command Interpreter
MS-DOS cannot find the COMMAND.COM file on the disk.
Either the file is missing from the ROOT directory, or the file is
invalid. Restart the system, or copy the COMMAND.COM file
from your master MS-DOS system disk to your working system
disk. You also receive this message if COMMAND.COM is not in
the same directory it was in when you started MS-DOS.
Bad or mi55ing
(filename)
You specified an invalid device in the CONFIG.SYS file. Check
the accuracy of the DEVICE command in CONFIG.SYS.
297