Tandy 1000 MS-DOS Reference Manual page 329

Chapter 14/ Problems and Error Messages
Invalid Parameter
You specified a switch other than /B when starting EDLIN.
Specify the /B switch when you start EDLIN.
Line too long
During a Replace command, the string given as the replacement
caused the line to expand beyond the limit of 253 characters.
EDLIN terminated the Replace command.
Divide the long line into two lines, and then try the Replace
command again.
, , MU5t 5pecify de5tlnation number
You did not specify a line number in a Copy or a Move command.
Renter the command, including a destination line number.
Not enough room to merge the entire flle
There is not enough room in memory to hold the file during a
Transfer c9mmand.
Free some memory by writing some files to disk or by deleting
some files before you can transfer the file.
No room in dlrectory for flle
You are trying to create a file, but either the file directory is full
or you are specifying and illegal disk drive or filename.
Check the command line that started EDLIN for either an ille-
gal filename or an illegal drive specification. If the command is
no longer on the screen, and if you have not yet typed a new
command, you can recover the command by pressing the Copy
All key, [ill.
If the command line contains no illegal entries, run the
CHKDSK program for the specified disk drive. If the status
report shows that the disk directory is full, remove the disk.
Insert and format a new disk.
307