Tandy 1000 MS-DOS Reference Manual page 300

Chapter 13/ The DEBUG Utility
Notes
• Overlapping moves (where some locations in the range are
also in the block beginning at address) are performed without
loss of data. The addresses in the range remain unchanged
unless new data is written to them by the move.
• If only an offset is used for the starting address of range or for
address, the segment indicated by register DS is used. To
specify an ending address for the range, enter only an offset
value.
Example
M CS:100 110 CS:500
I
ENTER
I
causes DEBUG to move the data that is between CS:l00 and
CS:110 to the memory area beginning at CS:500
NAME
N filespecl [filespec2 ...
J
Assigns filespecs or program names for later Load or Write com-
mands. If DEBUG is entered without naming any file, then you
must use the N filespec command before a file can be loaded. The
Name command also assigns filespec parameters to the file
being debugged.
Parameters
filespec1 filespec2 are names assigned to the files you will be
using with DEBUG.
280
i I
: I
. i
L
! '
L.;
)
I
~
)
I
I
L..;
L.J
I
i
,
L....'
I I
L
i
I ,
~
i
i
.
,
I
U