Tandy 1000 MS-DOS Reference Manual page 326

Chapter 14/ Problems and Error Messages
No room for system on destination disk
If the target disk contains files you don't need, use the ERASE
command to delete as many as necessary to make room for the
system. Otherwise, use a different disk as the target.
Out of environment space
There is not enough room in the program environment to accept
more data. You can use COMMAND with the
IE
switch to
increase the size of the environment.
Path too long
The pathname you specified is too long. You might have to
change to a lower subdirectory to replace files in deep
subdirectories.
PRINT gueue is empty
There are no files in the print queue.
PRINT gueue is full
The queue can contain no more than ten files.
Probable non-DOS disk
Continue (YIN)?
You are not using an MS-DOS disk. Type
Y
(ENTER
I
to continue
processing or
N
I
ENTER
I to stop processing.
Read error in pathname
FC could not read the entire file.
Sector size too large in file (filename)
The specified device driver loaded by CONFIG.SYS uses a sector
size larger than that of any other device driver on the system.
You cannot run this device driver.
Specified MS-DOS search directory bad
The SHELL command in the CONFIG.SYS file is incorrect.
Either COMMAND.COM is not in the place you indicated, or
that place does not exist.
Syntax error
Reenter the command, using the proper syntax.
304
I •
I
!