Tandy 1000 MS-DOS Reference Manual page 328

Chapter 14/ Problems and Error Messages
Disk full _ write not completed
You entered the End command, but the disk does not contain
enough free space for the whole file. EDLIN terminated the End
command and returned you to the operating system. Some of the
file may have been written to the disk.
Only part (if any) of the file is saved. Delete that part of the file
and restart the editing session. The file is not available after
this error. Before you begin any editing session, be sure the disk
has sufficient free space for the file.
Entry Error
The last command typed contained a syntax error. Reenter the
command, using the correct syntax.
File Creation Error
The EDLIN temporary file cannot be created.
Verify that the directory has enough space to create the tempo-
rary file. Also be sure that the file does not have the same name
as a subdirectory in the directory where the file to be edited is
located.
File name must be specified
You did not specify a filename when you started EDLIN. Specify
a filename whenever you start EDLIN.
File not found
The filename specified during a Transfer command was not
found. Specify a valid filename when issuing a Transfer
command.
Insufficlent memory
There is not enough memory to run EDLIN.
Free some memory by writing files to disk or by deleting files
before restarting EDLIN. Use the Write command and then the
Append command.
Invalid drive name or file
You specified an illegal drive or filename when you started
EDLIN. Specify a legal drive or filename.
306
,
.
1 ;
I
I~
,
'--