Tandy 1000 MS-DOS Reference Manual page 322

Chapter 14/ Problems and Error Messages
Error writing boot sector to destination
All floppy disks-both data and system disks-must have a boot
sector so that they may be used by the system. The disk is
either defective or needs to be reformatted.
Errors writing to the system cannot continue
Make sure you have a diskette in the drive specified by FOR-
MAT and the drive door is closed. Make sure any write-protect
tab is removed from the diskette to FORMAT. If the error per-
sists, your diskette is unusable.
EXEC failure
MS-DOS either found an error when reading a command, or the
FILES command in the CONFIG.SYS file has the number of
files set too low. Increase the value and restart MS-DOS.
file
canceled by operator
This is a reminder only. You used the
IC
parameter with PRINT
to cancel the current file in the print queue.
File cannot be converted
The source file is not in the correct format. CS:IP does not meet
either criterion discussed in the EXE2BIN command. CS:IP
meets the .com file criterion but has segment fixups. The file is
not a valid executable file.
File cannot be copied onto itself
You tried to copy a file to a file that has the same name. Either
change the -name of your copy, or put it in a different directory
or on a different disk.
File creation error
You tried unsuccessfully to add a file to the directory. You either
exceeded the files per directory, or the file already exists and is
perhaps a read-only file. Run CHKDSK to determine if some
other condition caused the error.
File not found
The specified file does not exist in the specified directory or the
current directory. Use the DIR command to see which directory
the file is in. Also check the spelling of the filename.
300
I
U
u
, I
i
i
'---'
u
I
I
, !
LJ
,
:
U
, I
: I
LJ
,
LJ
I
i
L..:
i
I
I
I
'--...!
,I
i
LJ
I
I
LJ
!
, I
--.J
j