Tandy 1000 MS-DOS Reference Manual page 199

,.,
!
r -
I
VOL (Volume)
1
VOL
[drive:]
Chapter 6 / Command Reference
Internal
Displays the volume label of the disk in the specified drive. (You
r
can assign a label by using the IV parameter in the FORMAT
!-
command.) If the disk does not have a volume label, VOL
displays:
~
Volume in drive
n
has no label
Parameters
drive: indicates the disk for which you wish to display the label.
If
you omit the drive, MS-DOS displays the volume label of the
current disk.
r
L.
r
,
r
L
...
l
~
i
Notes and Suggestions
• Enter the VOL command whenever you forget a volume label.
Example
vol b:
I
ENTER
I
MS-DOS displays a message similar to this:
Volume in drive
B
is
DISKONE
vo 1
I
ENTER
I
displays the volume label of the current disk.
185