Sense Data Conversion (Setting The Host Responses); Table 2.2 Reservation Conflict Response For Test Unit Ready Setting For Solaris Os; Table 2.3 Sense Data Conversion Pattern Setting For Solaris Os; Table 2.4 Host Specific Mode Setting For Hp-Ux - Fujitsu ETERNUS DX400 series Configuration Manual

Chapter 2 ETERNUS DX Connection Settings
2.1 Common Settings
Reset Scope
Reserve Cancel at Chip Reset
Header Digest
Data Digest
2.1.2

Sense Data Conversion (Setting the Host Responses)

The ETERNUS DX host responses must be set to match the way in which the server will process the ETERNUS DX
request responses.
These are different for each OS and this must be done before connecting the ETERNUS DX to the server.
Retain the default values for all parameters not described below.
2.1.2.1 Solaris OS
For Solaris OS, perform the settings detailed in
Table 2.2 Reservation Conflict Response for Test Unit Ready setting for Solaris OS
Solaris 10 OS
Table 2.3 Sense Data Conversion Pattern setting for Solaris OS
Solaris 10 OS
2.1.2.2 HP-UX
For HP-UX, set the [Host Specific Mode] to [HP-UX Mode (SCC)].
Table 2.4 Host Specific Mode setting for HP-UX
HP-UX
FUJITSU Storage ETERNUS DX Configuration Guide -Server Connection-
Parameter
I_T_L (Default value)
OFF (Default value)
OFF (Default value)
OFF (Default value)
OS
[Sense Data Conversion Pattern]
OS
OS [Host Specific Mode] setting
Copyright 2014 FUJITSU LIMITED
Solaris OS, HP-UX, Windows®, Linux, VMware ESX, Oracle VM Server
Table 2.2 and Table 2.3.
MPxIO (OS standard Multipath Driver)
Used
Conflict Response
setting
Linux Recommended
(When not using GRMPD)
HP-UX Mode (SCC)
9
Not used
Normal Response (Default)
P3AM-3972-08ENZ0