Fujitsu ETERNUS DX400 series Configuration Manual page 6

Chapter 1
Workflow
This manual is used when performing the setup procedures described in the "Setting up the ETERNUS DX"
section of the "FUJITSU Storage ETERNUS DX Configuration Guide -Server Connection- (iSCSI)" for each OS.
Workflow
Setting the CA Parameters
Set the to-server connection type.
Refer
-
"2.1.1 Setting the To-server Connection Type (Setting the CA Parameters)" (page 8)
Setting the Host Responses
Set the host responses to match the connection configuration.
Refer
-
"2.1.2 Sense Data Conversion (Setting the Host Responses)" (page 9)
Setting Server iSCSI
Set IP addresses, aliases, and iSCSI names for servers.
Refer
-
"2.1.3 Setting the Server iSCSI Host" (page 12)
FUJITSU Storage ETERNUS DX Configuration Guide -Server Connection-
Copyright 2014 FUJITSU LIMITED
6
P3AM-3972-08ENZ0