How To Setup The Access Point For Radius Authentication - 3Com 8250 User Manual

5
6
H
OW TO SETUP THE ACCESS POINT FOR
AUTHENTICATION
1
2
3
4
5
6
7
8
9
10 Make sure the following settings are set from the Security page:
128-bit—Each key contains 26 hexadecimal digits or 13 alphanumeric
characters.
152-bit—Each key contains 32 hexadecimal digits or 16 alphanumeric
characters.
3Com Passphrase—This encryption string is for use only with other 3Com
Wireless LAN devices. It is a case-sensitive string between 6 and 30 characters
long. To enter the string, click 3Com Passphrase. Then type any combination
of letters and numbers in the Key 1 field and click Apply.
Uncheck box under WPA Configuration
Choose the WEP option under Multicast Cipher Mode.
Using the Wireless Infrastructure Device Manger access the configuration
screen for the access point.
Enter your User Name and Password and click LOGIN (Default: admin with no
password)
Select Advanced Setup.
Click on RADIUS from the left frame page Menu.
Enter all the settings of your Primary RADIUS Authentication Server (make
sure the IP Address and Key match those on the RADIUS Authentication
software).
Click on Apply
Choose Authentication from the left frame page Menu
Make sure the following settings are set on the Authentication page:
a MAC Authentication is Disabled. (if Local or RADIUS MAC Authentication
is chosen MAC address filtering or authentication, respectively, will be
done before the 802.1x authentication. Therefore, these setups must be
validated individually and verified functional before 802.1x can be done).
b 802.1x Wireless Setup: is set to Supported (if non-RADIUS clients need
access too) or Required (if only RADIUS clients are to be allowed).
c Click on Apply.
Click Security on the 802.11a/b/g radio from the left frame page Menu
a Authentication is set to Open System
RADIUS
61