System Log; Link Configuration - 3Com 8250 User Manual

Link Configuration

There are two parameters for the Ethernet link and each WDS link:
S L
YSTEM OG
The System Log page allows you to set up a server to store event logs and to
specify how the access point obtains the date and time. When you are finished
configuring items on this page, click Apply.
Each logging message is tagged with a severity level, as defined in RFC3164. The
severity levels are:
To set up a server for event logs: Select System Log Setup Enable, select a
logging severity level from the pulldown list, enable the Logging Host and
Logging Console, and enter the IP address of the server in the space provided.
To designate an SNTP server for obtaining the date and time: Select SNTP
Server Enable and enter the IP addresses for primary and secondary SNTP servers
in the spaces provided.
Bridge Hello Time (1-10 sec.)—Enter a value to determine how often the
access point broadcasts the hello message.
Bridge Forwarding Delay (4-30 sec.)—Enter a value to determine how long
the access point remains in listening and learning states before its ports enter
the forwarding state.
Link Path Cost (1-65535)—Enter a value to determine the cost of forwarding
data through this link. Higher cost means the link is less efficient.
Link Port Priority (0-255)—Enter a value to determine the preferred link to
forward data when a network loop is detected. Lower values mean higher priority.
Emergency: system is unusable
Alert: action must be taken immediately
Critical: critical conditions
Error: error conditions
Warning: warning conditions
Notice: normal but significant condition
Informational: informational messages
Debug: debug-level messages
52