Basic Setup - 3Com 8250 User Manual

B S
ASIC ETUP
For a basic configuration, use the Setup Wizard as described below.
At any time, you can click Home to return to the Home page of the configuration
interface. If you want to configure more advanced features, click Advanced Setup
in the Home page.
1
2
3
4
5
6
7
8
In the Home page, click Setup Wizard.
In the "1-2-3" Setup Wizard page, select a Virtual Access Point (VAP) you
want to set up, and then click Next to start basic configuration.
In the SSID page, enter the same Service Set ID as the other wireless devices in
your network and click Next. (The SSID may be up to 32 alphanumeric
characters and is case sensitive.)
In the Channel page, select the channel options for the access point radios
and click Next. The channel options are:
802.11a—You can select from these options:
Turbo Mode—In some countries you can use Turbo Mode, allowing the
access point to operate with a data rate of up to 108 Mbps. If Turbo Mode
is not allowed in your country, this option is not available.
802.11a Radio Channel—Set the operating radio channel number.
Auto Channel Select—When this mode is enabled, the access point selects
a radio channel automatically.
802.11g—You can select from these options:
Turbo Mode—In some countries you can use Turbo Mode. If Turbo Mode
is not allowed in your country, this option is not available.
802.11g Radio Channel—Set the operating radio channel number.
Auto Channel Select—When this mode is enabled, the access point selects
a radio channel automatically.
802.11b—Set the operating radio channel number.
In the TCP/IP Settings page, you can choose whether the access point obtains
its IP address from a DHCP server or uses a static IP address. Configure the
DHCP Client settings and click Next.
In the Security page, make selections and click Next.
For details on security settings, see "Security" on page 58.
Click Finish.
Click OK to restart the access point.
32