Follett C25R5A/W Operation, Service And Parts Manual page 10

Ice transport tube replacement – models F255A/W, F505A/W, C25R5A/W, C50R5A/W
Correct installation of ice transport tube is critical to remote icemaker performance.
!
Replacement ice transport tubes for remote icemakers must be insulated and run continuously
from icemaker to dispenser with no dips or bends with a radius of less than 6"(153mm).
1. Remove top and rear access panel from dispenser (and lower front panel on freestanding unit).
2. Disconnect existing ice tube from engaging pin in ice storage bin and pull down through dispenser chase.
3. Disconnect opposite end of tube from icemaker.
4. Run end of new ice transport tube with 3/16" (5mm) hole through right hand knockout in back of dispenser or through
counter into bottom of dispenser, being careful to avoid any bends with less than 6" (153mm) radius.
5. Insert tube in internal chase in rear inside corner of dispenser (right side as you face rear of dispenser) and push up
into storage area.
6. Push the 3/16" hole near end of tube into pin on ice tube bracket (see drawing below).
Steps 7-8 for units with remote icemakers
7. Install supplied insulation to run of transport tube required
for your site, leaving approximately 2" (51mm) of tube
exposed at free end.
8. Check that insulated tube runs continuously to dispenser
with no dips.
All units
9. Place free end of tube in a cup of hot water to soften, slip
supplied hose clamp onto tube and push tube onto exit
port of evaporator. DO NOT TWIST HOSE WHEN
SECURING TO EVAPORATOR.
10. Fasten tube on port with hose clamp, being sure that
clamp is positioned on evaporator side of flange.
11. Tighten clamp.
only
10
capillary
tube
ice tube
bracket
(5mm)
hole in
ice tube
New Style Bracket
Section A – A
A
1"
(26mm)
engaging pin
3/16"
ice
tube
Back wall
.1875" (5mm)
dia. hole
1"
(26mm)
A