Table of Contents
Advertisement
DRIVIO BELT
Removal
1.
Remove the control and data circuit board.
2.
Remove the chassis shield.
3.
Remove the diskette lever assembly.
4.
Remove the front panel.
5.
Remove the servo circuit board.
6.
Remove the bottom index sensor.
7 •
Remove the upper plate assembly.
8.
Unloop the drive belt from the drive motor pulley.
9.
Lift out the drive belt throuyh the slot in the chassis.
Installation
1.
Twist the belt so the shiny side is inward.
2.
Push the new belt through the slot in the chassis, loopiny
the belt around the spindle pulley.
3.
While turning the spindle pulley, loop the other end of the
belt around the drive motor pu lley.
4.
Ensure the spindle pulley, drive belt, and drive motor
rotate freely.
5.
Replace the upper plate assembly.
6.
Replace the bottom index sensor.
7.
Replace the servo circuit board.
8.
Replace the front panel.
9.
Replace the diskette lever assembly.
10.
Replace the chassis shield.
11.
Replace the control and data circuit board.
6-17
Advertisement
Table of Contents
