Table of Contents
Advertisement
4.
Push the bracket to the front of the drive, and remove it.
5.
The power input pluU has
Number 2 is to the servo
drive; PluU Number 7, on
and data circuit board.
them from the drive.
two cables runninu from it:
pluU
circuit board on the bottom of
top of the drive,
is to the control
Disconnect both pluus and remove
Installation
1.
Position the power input plug on the chassis with rounded
corners to the top and next to the chassis retaining forms.
2.
Route cable pluU Number 2 through the hole in the chassis to
the bottom of drive.
Cable plug Number 7 remains on the same
side as the power input pluU.
CAUTION
TH~S~
CABLE PLUGS CANNOT BE REVERSElJ.
POWER
APPLIED IS NOT THE SAME PIN OUTS ON THE
CIR.CUIT BOARD.
3.
Put the bracket over the hole in the chassis, and line it up
with the power input plug.
The bracket must engage with the
chassis through the hole.
The power input plug goes against
the chassis retaining forms.
4.
Secure the bracket with a Number I Phillips screw into the
chassis standoff.
5.
Replace the chassis shield.
6.
Replace the control and data circuit board.
WRITE PROTECT SWITCH
Removal
1.
Remove Pil from the control and data circuit board.
2.
Cut the tie wraps, as required, to route Plug Pll through the
hole in the chassis to the bottom of the drive.
3.
Remove the servo circuit board.
6-6
Advertisement
Table of Contents
