Table of Contents
Advertisement
2.
Secure the circuit board using the short Number 1 Phillips
screw through the mounting hole at the front.
The longer
Number I
Phillips screw is used through the heat sink
on the circuit board.
3.
Connect all cable plugs (Figure 6-2).
CHASSIS SHIELD, CONTROL AND DATA CIRCUIT BOARD
Removal
1.
Remove the control and data circuit board.
2.
Remove the Number 1 Phillips screw's retaining shield.
NOTE
HEAD CABLING IS AT THE FRONT OF THE DRIVE.
3.
Lift the shield from the chassis.
Installation
1.
Position the head cables along the chassis to exit the slot
of the shield at the front of the drive.
2.
position the shield, securing it with a Number 1 Phillips
screw through the mounting hole.
3.
Replace the circuit board.
DISKETTE LEVER ASSEMBLY
Removal
1.
Using a flat blade screwdriver. pry off the plastic door
handle (Figure 6-3).
2.
Remove the stud from the door shaft.
Installation
1.
Replace the stud in the door shaft.
2.
Position the door handle over the shaft and stud.
3.
Press in until the stud is covered by the door handle.
6-3
Advertisement
Table of Contents
