Compliance Adjustment
Compliance
is
adjusted
by
usiny
the
same
procedure
used in the
compliance check.
In addition:
1.
The spring tension for the pad arm has three positions for
the spring end in the lower portion on the head carriage
assembly (see Figure 5-14).
2.
While monitoring the oscilloscope, change the spring tension
position.
If output amplitude is not affected by different
positions of the spring, replace it.
3.
If the pad is worn, replace it.
COl'll'LlANCE SPRING
'~OMP:':)flCE
SPRING
liAS
7ciREE
TE:-ls:aN POSI!IONS, ANGLE OF
5;..0: JETI:RMINES SPRING TENSION
PIGLJRl:: 5-14
UPPER ARM AND COMPLIANCE SPRING
5-21