Table of Contents
Advertisement
TRACK () ::iE:NSOR AND TRACK () ::iTOP !jLOCK
Removal
1.
Remove cable Plug P9 from the control and data
circuit board.
2.
Remove the tie wraps, as required,
to free the cable to
the sensor.
3.
Move the head assembly toward the spindle.
4.
Remove two Number 1 Phillips screws from the Track 0 sensor
(Figure 6-8).
NOTE:
THE: ::iCREW TOWARD THE: REAR OF THE: DRIVE: IS GOING
THROUGH TI'iO PIECE:S, ONE: IS THE: TI<ACK 0 SE:NSOI<,
THE: ::iE:COND ONE IS THE TRACK 0 STOP BLOCK.
Installation
L
Position the Track () sensor over the retaining holes in
the chassis.
2.
Insert the retaining screw into the sensor toward the
front of the drive.
3.
Insert the screw through the Track 0 stop block and into the
rear retaining slot of the Track () sensor.
4.
Slide the Track 0 stop block toward the rear before
tightening the screw.
5.
Route the cable for the Track 0 sensor back to the control
and data circuit board.
6.
Apply tie wraps, as required.
6-14
Advertisement
Table of Contents
