2.
Insert three Number 1 Phillips screws, two at I:he front of
the drive, and one at the rear of the drive by the
drive motor.
3.
Apply four-inch pounds torque, maximum,
to the screws.
NOTE
LEAVE THE MOUNTING HOLE ON TilE POWER INPUT
PLUG SID,: OF Tlif: UPPEI, PLAn: ASSEMbLY
,;r~PTY.
THE CHASSIS SHIELDING RETA1NINl; SCREW USES
TKIS KOLE.
3.
Replace the spring on the lift plate.
4.
Route the lower index assembly through a hole in the chassis,
and mount it on the bottom of the drive.
5.
Route the cabling, using the tie wraps provided.
6.
Replace the servo circuit board.
7.
9.
10.
Replace the front panel.
Replace the diskette lever assembly.
Replace the chassis shielding.
Replace the control and data circuit board.
MOUNTING SCREWS
LIFT PLATE
SPRING
fIGURE 6-7
UPPER PLATE ASSEMBLY
6-13