Table of Contents
Advertisement
Mode Available In
Mode
the Web
Wireless Universal
Repeater
Repeater (default)
WDS
Bridge (default)
AP
Router
Client
Client (default)
Table 4.1 IP information of AP/Repeater/Client modes of WNAP1260
Step 1 Set the three-way switch on the case of WNAP-1260 to the mode you want.
Step 2 Run the Internet Explorer (IE). Enter the management IP address of 192.168.1.253 and press
Enter. In the login window that is displayed, enter the user name and password (both admin),
and click Login.
Step 3 Configure parameters for the mode you selected.
Terminal devices can access the network through WNAP-1260 after you finish configuration by
following procedures in the sections below.
5.1. Repeater Mode Configuration
Step 1 Set the three-way switch on the side panel to Repeater after WNAP-1260 is powered on. Log
in to the configuration page after the system is started.
Chapter 5. Quick Mode Configuration
LAN1 (Management
IP Address)
192.168.1.253
192.168.1.253
192.168.1.253
Figure 5-1
-25-
User's Manual of WNAP-1260
LAN2
DHCP
Way of connecting to PC
Server
(DHCP)
Yes
Disable
Ethernet cable /Wireless
No
No
Disable
Ethernet cable /Wireless
No
Enable
No
Disable
Wireless only
Ethernet cable only
Hide quick links:
Advertisement
Table of Contents
