Planet WNAP-1260 User Manual page 106

Click Add to add a static routing rule.
Object
 Active:
 Route Name:
 Destination IP
Address:
 IP Subnet Mask:
 Gateway IP
Address:
 Metric:
After finishing settings, click Apply to save the settings.
Figure 8-41
Figure 8-42
Description
The static routing rule can take effect only if the Active check box is
selected.
Enter the name of the static route.
The destination address or network that you want to access. This IP
address cannot be in the same network segment as the IP address
of the WAN or LAN interface of WNAP-1260.
This IP subnet mask together with the destination IP address identify
the target network
The IP address of the next node to which packets are sent. The
gateway IP address must be in the same network segment as the IP
address of the WAN or LAN interface of WNAP-1260.
The number of other routers in the user network. The value ranges
from 2 to 15. Usually, the value of 2 or 3 leads to the best
performance. If the route is direct connection, set Metric to 2
-98-
User's Manual of WNAP-1260