Planet WNAP-1260 User Manual page 102

Object
 Enable Port
Triggering:
 Port Triggering
Timeout:
Click the Add Service button and the Port Triggering – Services page is displayed:
Object
 Service Name:
 Service User:
 Service Type:
 Triggering Starting
Port:
 Triggering Ending
Port:
 Starting Port:
Ending Port:

After finishing settings, click Apply to add a port triggering rule.
Description
If Enable Port Triggering box is not checked, all port triggering
function will be disabled
The timeout value controls the inactive timer at the specified ingress
port. Upon timeout of the inactive timer, the ingress port is disabled
Figure 8-36
Description
Enter a service name
 Any: Allow everybody in the user network to use the service.
Single address: Enter the IP address of the network adapter

on the PC. Then, the service is applied only on the specific
network adapter of the PC.
The protocol used at the triggering port. You can select TCP/UDP,
TCP, or UDP
The first port to which an application sends a connection request. All
relevant ports can be open only after connection is established at
this starting port. Otherwise, other relevant ports are not open.
Set the end port of the triggering port range.
The starting port of the port range
The ending port of the port range.
-94-
User's Manual of WNAP-1260