Planet WNAP-1260 User Manual page 109

 Black List: Indicates to prevent service that complies with the rule in the Block Service
Rules Table-Black List area from being used.
 White List: Indicates to allow only service that complies with the rule in the Block
Service Rules Table-White List area to be available for use.
Step 2 Click Add to specify a service for blocking. The Block Services Setup page is displayed:
Step 3 Set the parameters in this page.
Object

Service Type:

Protocol:

Starting
Port/Ending Port:

Service Type/User
Defined:

Filter Service For:
After finishing settings, click Add to add a new rule. Then, click Apply to save the settings.
Figure 8-45
Description
Select a service type. If your desired type is not in the list, select
User defined.
Then, you need to select the protocol, enter the service name, and
specify the port range. For services that exist in the drop-down list,
the corresponding information is already preset.
Set the protocol used at service ports. If you are not sure about the
protocol that the application uses, select TCP/UDP.
The starting and ending ports of the port range where the specified
service is blocked. If the application uses a single port number, enter
the number in both fields
Enter the service name
You can block the specified service for a single computer, computers
within an IP address range, or all computers
-101-
User's Manual of WNAP-1260