3
PT-602CZ Configuration
3.3
The settings you make in this screen will become active when the software override DIP switch is set
to Off (the default), allowing software settings to control the camera. Refer to paragraph 1.15 "Setting
Configuration Dip Switches" on page 1-10.
Step 1
Step 2
Step 3
Select Device ID 1
Step 4
Step 5
3-4
Serial Remote Menu
Click Serial Remote. The following screen will be displayed.
Select the Protocol for your serial control configuration
(Pelco-D Serial Remote in this example).If the setting is changed, click Save.
After the page refreshes, select Device ID: 1 to see the Pelco-D settings.
After the page refreshes, enter the parameters for your specific location.
After the parameters are set, select Save and stop and restart the server to make the
changes effective.
PT-602CZ-12 Rev 100
April 2012