Installing Your Morsø Stove - Morso 2040 Instructions For Installation And Use Manual

1.6 Fluepipe connections
Your stove is supplied ready with a cast cover plate both in the cast top- and cast rear panel.
Where a rear or top flue installation is required, simply knock out the round panel cut in the
top heat panel or rear heat panel. This is best done by applying gentle hammer taps imme-
diately onto the small "bridges" in the circular cut-outs. Once the knock-outs have been re-
moved untwist the cast cover plate anticlockwise and remove. Install the cast flue collar using
the bolts and clamps attached.
how to position the access door
The access baffle has the number 066 cast into its upper face; it can be found inside the ash
pan. Before the initial lighting the access door is positioned in the baffle
Note: The access baffle must always be fitted when the stove is in use, as it not only assists
the combustion process, but also gives essential protection to the stove's top plate.
1.7 Connecting the stove to a masonry chimney
A wall sleeve should be bricked securely into the wall of the chimney at the appropriate height
and the stovepipe inserted centrally. The pipe must not extend into the actual chimney open-
ing, but rather must reach only to the inside of the chimney aperture. The gap between the
stovepipe and sleeve must be sealed using glass fibre packing rope.
Only use stovepipe components that comply to National and Local Building Regulations.