Advertisement
(2) Pull the relay harness from the receiver (1) up to where
the clamp (10) meets the stopper, as shown above.
(Refer to (2) in drawing)
(3) Install the receiver (1) where the decoration corner
panel was. Proceed in the opposite order in which you
removed the corner panel. (Refer to (3) in drawing)
(4) Fit the relay harness under the tab on the decoration
panel and connect it to connector X24A on the indoor
unit PC board. Bundle the remaining harness with the
included clamp so that it does not droop or get pinched
in the suction grille. (Refer to (4) in drawing)
(5) Attach the lid to the indoor unit's control box and the
suction grille to the decoration panel. (Refer to installa-
tion manual of indoor unit.)
4-5. Setting the address of wireless remote controller
(It is factory set to "1".)
<Setting from the remote controller>
Mode
SETTING
Address
Multiple setting
(1) Hold down the "
button for at least 4 seconds to get the FIELD SET
MODE. (Indicated in the display area in the figure at top.)
(2) Press the "
" button and select a multiple setting
FAN
(A/b). Each time the button is pressed the display
switches between "A" and "b".
(3) Press the "
" button and "
UP
address.
Address can be set from 1 to 6, but set it from 1 to 3 and
to same address as the receiver. (The receiver does
not work with address from 4 to 6.)
(4) Press the "
RESERVE
(5) Push the "
TEST
MODE and return to the normal display.
<Multiple settings A/b>
When the indoor unit is being operating by outside control (cen-
tral remote controller, etc.), it sometimes does not respond to
ON/OFF and temperature setting commands from this remote
controller. Check what setting the customer wants and make the
multiple setting as shown below.
ON OFF
TEMP
(3)
TIME
UP
DOWN
FAN
(2)
RESERVE CANCEL
TIMER
(4)
MODE
SWING
(1)
TEST
(5)
" button and the "
"
TEST
" button to set the
DOWN
" button to enter the setting.
" button to quit the FIELD SET
Remote controller
Multiple setting
Remote control-
ler display
A: Standard
All items dis-
played.
b: Multi System Operations remain
displayed shortly
after execution
4-6. Stick the Unit No. label on the air outlet of the decoration
panel and the back of the wireless remote controller.
CAUTION
Set the Unit No. of the receiver and the wireless remote con-
troller to be equal. If the settings differ, the signal from the
remote controller cannot be transmitted.
5.
FIELD SETTING
If optional accessories are mounted on the indoor unit, the
indoor unit setting may have to be changed. Refer to the instruc-
tion manual (optional hand book ) for each optional accessory.
ON OFF
TEMP
TIME
UP
SETTING
DOWN
FAN
RESERVE CANCEL
TIMER
MODE
SWING
TEST
Procedure
(1) When in the normal mode, press the "
ton for at least 4 seconds, and the FIELD SET MODE is
entered.
Indoor unit
To control other
For other than
air conditions
on left
and units
Commands other
than ON/OFF
and temperature
setting accepted.
(1 LONG BEEP
or 3 SHORT
BEEPS emitted)
All commands accepted.
(2 SHORT BEEPS)
MODE NO.
FIELD SET MODE
(3)
(4)
(5)
SECOND CODE NO.
FIRST CODE NO.
(2)
(1) (6)
" but-
TEST
4
Advertisement
