Advertisement
(4) Press the "
RESERVE
(5) Push the "
TEST
MODE and return to the normal display.
<Multiple settings A/b>
When the indoor unit is being operating by outside control (cen-
tral remote controller, etc.), it sometimes does not respond to
ON/OFF and temperature setting commands from this remote
controller. Check what setting the customer wants and make the
multiple setting as shown below.
Remote controller
Multiple setting
Remote control-
ler display
A: Standard
All items dis-
played.
b: Multi System Operations remain
displayed shortly
after execution
4-7. Stick the Unit No. label at the indoor unit and the back of
the wireless remote controller.
Unit No. label (7)
CAUTION
Set the Unit No. of the receiver and the wireless remote con-
troller to be equal. If the settings differ, the signal from the
remote controller cannot be transmitted.
5
" button to enter the setting.
" button to quit the FIELD SET
Indoor unit
To control other
For other than
air conditions
on left
and units
Commands other
than ON/OFF
and temperature
setting accepted.
(1 LONG BEEP
or 3 SHORT
BEEPS emitted)
All commands accepted.
(2 SHORT BEEPS)
Wireless remote
controller (4)
5.
FIELD SETTING
If optional accessories are mounted on the indoor unit, the
indoor unit setting may have to be changed. Refer to the instruc-
tion manual (optional hand book ) for each optional accessory.
ON OFF
TEMP
TIME
UP
SETTING
DOWN
FAN
RESERVE CANCEL
TIMER
MODE
SWING
TEST
Procedure
(1) When in the normal mode, press the "
ton for at least 4 seconds, and the FIELD SET MODE is
entered.
(2) Select the desired MODE NO. with the "
(3) Push the "
" button and select the FIRST CODE NO..
UP
(4) Push the "
" button and select the SECOND CODE
DOWN
NO..
(5) Push the"
RESERVE
are set.
(6) Push the "
TEST
MODE and return to the normal display.
(Example) If the time to clean air filter is set to "Filter Con-
tamination-Heavy", set Mode No. to "10", FIRST
CODE NO. to "0", and SECOND CODE NO. to
"02".
FIRST
MODE
CODE
DESCRIPTION OF SETTING
NO.
NO.
Filter Contamination-Heavy/Light
(Setting for spacing time of display
time to clean air filter) (Setting for
0
when filter contamination is heavy,
10
and spacing time of display time to
clean air filter is to be halved)
Spacing time of display time to clean air filter count
3
(Setting for when the filter sign is not to be displayed)
ON/OFF input from outside (Set to enable starting/
1
12
stopping from remote.)
(VRV
Thermostat differential changeover (Set when using
system)
2
remote controller thermostat sensor.)
MODE NO.
FIELD SET MODE
(3)
(4)
(5)
SECOND CODE NO.
FIRST CODE NO.
(2)
(1) (6)
TEST
" button.
MODE
"button and the present settings
" button to quit the FIELD SET
Long-life type
Standard type
" but-
Advertisement
