Table of Contents
Advertisement
T a l k m a s t e r
X T
®
P A G E 6 2
S o f t w a r e
5.5.2.2.6
Audio Interface
b-line XT supports analogue as well as digital AES/EBU Audio interfaces. If
the digital Audio inputs are used, a Sample Rate Converter is available so that
external adjustments are not required if there are different digital sources and
drains.
FIG. 37
Mode
• The operating mode analogue or digital can be set separately for the Au-
dio Input and the Audio Output.
AES/EBU Interface
• If the digital output is selected, the configuration for the AES/EBU Inter-
face is displayed. Under Clock Source of digital output you can select
the following options:
– Internal: The AES/EBU output clock is derived from the internal sys-
tem clock.
– External: The AES/EBU output clock is derived by the external clock
connected via the interface Audio 2/CLK IN. The clock rate of the con-
nected clock must be 48-kHz.
– Recovered: The AES/EBU output clock is derived from the digital in-
put signal of the interface Audio 1/AES IN. This configuration is usually
to be selected if you use the digital input of the system. In this way a
synchronous functioning of the transmission chain is ensured
NOTE
The AES/EBU input always works with recovered clock, therefore a config-
uration of the output is required.
For clock synchronisation to other systems you can use the Audio output Au-
dio 2/CLK OUT. The clock rate of the output clock is 48-kHz.
AUDIO INTERFACE
Advertisement
Table of Contents
