Install Facing In The Correct Direction - Canon WUX6000 User Manual

■ Install Facing in the Correct Direction

• The projector can be installed facing any direction*
below. However, projection upward or downward may shorten the
useful life of the lamp. [Install settings] of the projector must also
be adjusted. Specifically, for upward or downward projection, refer
to instructions for [Vertical projection] (P147) in the [Install
settings] menu.
• Do not attempt to install the projector for upward or downward
projection by yourself. Always request installation by a qualified
technician or the Canon Customer Support Center.
10° 10°
Upward
projection:
Inclination of the
projector should
be no more than
10° from the
2
vertical axis.*
10°
10°
*1 No optional accessories are available for installing the projector in
ways other than ceiling installation (P119, P227).
*2 An inclination of more than 10 degrees may damage the lamp.
When installing the projector facing upward or downward, specify which way the projector
is facing in [Install settings] > [Professional settings] > [Vertical projection]. (P147)
If installing the
projector on the floor
or hanging from the
ceiling, the left / right
inclination of the
projector should be no
2
more than 10°.*
117
Before Installation
1
, as shown
10° 10°
Downward
projection:
Inclination of the
projector should
be no more than
10° from the
2
vertical axis.*
Do not use the
projector standing
on its side. This may
2
damage the lamp.*