Input Terminal - Canon WUX6000 User Manual

Part Names

Input Terminal

(1)
(4)
(1) Terminal for wired remote control (REMOTE) (P30)
Connects to an optional wired remote control (RS-RC05).
(2) AUDIO IN terminal (AUDIO IN) (P132, P133, P136)
Receives the audio signal input for 2 kinds of image input other than HDMI.
The internal speaker outputs the audio for the selected image signal.
(3) AUDIO OUT terminal (AUDIO OUT) (P134, P137)
Outputs audio to an external speaker or other audio equipment. This outputs
the audio signal that corresponds to the projected image signal.
(4) USB port (P65)
Connects a USB flash drive. Used for projection of images on a USB flash
drive, or for firmware updates.
(5) Analog PC-1 / DVI-I input terminal (
Connects the external monitor output from a computer.
Receives analog and digital PC signals (Analog PC-1 and Digital PC,
respectively).
(6) Analog PC-2 / COMPONENT input terminal (
P136)
Receives the analog PC signal (Analog PC-2).
A component cable can be used to receive the component image signal
(Component).
(7) HDMI input terminal (HDMI) (P134)
Receives digital video signals (HDMI).
Carries both video and audio signals across a single cable.
(8) LAN port (P164)
Connects the LAN cable (shielded twisted pair).
Used to connect the projector to a network.
(9) Service port (CONTROL)
It is not used during ordinary use.
(2) (3)
(5) (6) (7)
36
(8)
DVI-I) (P132, P133)
/ COMPONENT) (P132,
(9)