You Cannot Project An Image From The Projector - Canon WUX6000 User Manual

Troubleshooting
The lens connector is
not attached correctly.
The air filter is not
installed correctly.
Key lock is enabled.

■ You Cannot Project an Image from the Projector

Cause
A cable is not connected
correctly.
20 seconds have not
elapsed since the
projector was turned on.
No image is sent from
the AV equipment.
Connection with the
input terminal has not
been performed
correctly.
No input signal type has
been selected for the
connected AV
equipment.
The input signal type is
incorrect.
The BLANK function has
been selected.
No image is projected
due to a problem with
the computer.
The lens cable is not connected to the lens unit
correctly. Unplug the projector, connect the lens
cable to the lens unit correctly, and then plug the
projector in again. Contact the Canon Customer
Support Center if the same warning occurs again.
Check whether the air filter is installed correctly.
(P196)
Check that Key lock (P101) is not enabled for the
projector or the remote control.
Countermeasure
Check whether the projector is connected to the
computer or AV equipment correctly. (P132, P135)
When the projector is turned on, the opening window
is displayed for approximately 20 seconds. To project
an image immediately, press the OK button on the
remote control or side control. (P38)
Check whether an image is played on the connected
video camcorder, DVD, etc.
Check whether the AV equipment is connected to the
projector input terminal correctly. (P131)
Check that the same input signal has been correctly
selected for the connected AV equipment from the
[INPUT] menu. (P40)
Check whether the selected input signal type is
correct. (P76, P214)
Press the BLANK button on the remote control.
(P62)
Turn first the projector and then the computer off and
then back on again.
204