Waste Toner Bottle Contact Block Removal - Lexmark X548 Series Service Manual

7525-63x

Waste toner bottle contact block removal

1. Open the front cover.
Remove the right cover assembly. See
2.
3. Remove the waste toner bottle. See
Remove the screw (A) from the back of the waste toner bottle contact block.
4.
Remove the rear shield. See
5.
Disconnect the waste toner bottle contact block cable from connector JWT1 on the RIP board.
6.
Remove the waste toner bottle contact block.
7.
Service Manual
4-74
"Right cover removal" on page
"Waste toner bottle removal" on page
"Rear shield removal" on page
4-7.
4-73.
4-7.
Previous
Next
Go Back