Lexmark X548 Series Service Manual page 70

7525-63x
Fax error log codes
Error code
883
884
885
886
887
888
889
88A
901
902
903
904
905
906
907
908
Service Manual
2-26
Description
Failure to transmit training successfully
in V.17, V.27 terminal modulation
schemes.
Failure to transmit training successfully
in V.29, V.27 terminal modulation
schemes.
Failure to transmit training successfully
in V.17 terminal modulation scheme.
Failure to transmit training successfully
in V.29 terminal modulation scheme.
Failure to transmit training successfully
in V.27 terminal modulation scheme.
Failure to transmit training successfully
at 2400 bps in V.27 terminal
modulation scheme.
Failed to connect at the minimum
speed supported by the MFP.
Failed to connect using V.34
modulation scheme.
No fax tones detected from remote
end.
No dial tone detected.
Busy tone detected.
Hardware error detected.
A timeout occurred after dialing the
number and waiting for a response.
Fax cancelled by user.
Modem detected a digital line
connection.
Phone line was disconnected
Action
• Select a lower Max Speed under Fax
Send settings.
• Adjust Transmit Level.
• Check line quality.
• Select a lower Max Speed under Fax
Send settings.
• Adjust Transmit Level.
• Check line quality.
• Select a lower Max Speed under Fax
Send settings.
• Adjust Transmit Level.
• Check line quality.
• Select a lower Max Speed under Fax
Send settings.
• Adjust Transmit Level.
• Check line quality.
• Select a lower Max Speed under Fax
Send settings.
• Adjust Transmit Level.
• Check line quality.
• Adjust Transmit Level.
• Check line quality.
• Adjust Transmit Level.
• Incompatible connection.
• Check line quality.
• Adjust to a lower modulation scheme.
• Adjust Transmit Level Receive
Threshold values.
• Verify destination phone number.
• Verify that the remote fax is authorized
to receive faxes.
• Check by enabling Behind a PABX
setting.
• Check phone line.
• Check MFD modem hardware.
Check with remote end if successive
attempts fail.
See
"Modem/fax card service check" on
page 2-66.
Check with remote end if successive
attempts fail.
No action needed.
Verify the MFP is connected to an analog
line. See"Fax transmission service
check" on page 2-67.
Restore phone line connection.
Previous
Next
Go Back