Download Print this page

Motorola AP6522E Installation Manual: Us And Canada; Power Supply; Wireless Devices - Countries; Operation In The Us And Canada

Hide thumbs

Advertisement

38

5.4.4 US and Canada

Co-located statement
To comply with FCC RF exposure compliance requirement, the antennas used for this transmitter must not be
co-located or operating in conjunction with any other transmitter/antenna except those already approved in this
filling.
Remote and Standalone Antenna Configurations
To comply with FCC RF exposure requirements, antennas that are mounted externally at remote locations or
operating near users at stand-alone desktop of similar configurations must operate with a minimum separation
distance of 20 cm from all persons.
5.5 Power Supply
Use ONLY a LISTED Motorola, Type no. PWRS-14000-148R (12VDC @ 4.16A), direct plug-in power supply, marked
Class 2 (IEC60950-1, SELV).
This device can be powered from a 802.3af compliant power source which is certified by the appropriate agencies.
Use of alternative Power Supply will invalidate any approvals given to this unit and may be dangerous.
5.6 Wireless Devices - Countries
5.6.1 Country Selection
Select only the country in which you are using the device. Any other selection will make the operation of this device
illegal.
NOTE
5.6.2 Operation in the US and Canada
The use on UNII (Unlicensed National Information Infrastructure) Band 1 5150-5250 MHz is restricted to indoor use
only, any other use will make the operation of this device illegal.
The available channels for 802.11 bg operation in the US are Channels 1 to 11. The range of channels is limited by
firmware.
5.6.3 Radio Frequency Interference Requirements—FCC
This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to Part 15 of the FCC rules. These limits are designed to provide reasonable protection
against harmful interference in a residential installation. This equipment generates, uses and can
radiate radio frequency energy and, if not installed and used in accordance with the instructions,
The US only models (AP-6522-66030-US and AP-6522-66040-US) have the country code
permanently set to the US. The WR models (AP-6522-66030-WR and AP-6522-66040-WR)
cannot be configured for use in the US.
AP6522E Access Point

Advertisement

Comments to this Manuals

Symbols: 0
Latest comments: