Maintenance
System Tests
Your security system is only as effective as each of the components. This includes your
sirens, communicator, back up battery, and detection devices.
Each of these should be regularly tested and maintained to provide the highest level of
security. Failure to conduct regular testing can result in system failure when most required.
The four system tests to perform are:
Perform a Walk Test
This is an important test to use regularly to verify that each sensor is working correctly.
Example: How to perform a sensor walk test
1.
YOUR 4 OR 6 DIGIT INSTALLER CODE
2.
3.
Walk past each motion sensor, open and close
windows and doors with sensors
4.
5.
MENU
6.
Perform a Siren Test
The Sirens are used as audible deterrents in the event of your security system activating.
As this test sounds all the audible devices connected to your security system, it is
advisable to notify neighbors and other persons within the premises prior to activating this
test. Using hearing protection is also recommended.
Example: How to perform a siren test
1.
YOUR 4 OR 6 DIGIT INSTALLER CODE
2.
3.
4.
MENU
5.
ZeroWire Installation Manual
MENU
4
ENTER
4
STATUS
MENU
MENU
MENU
4
ENTER
1
MUTE
MENU
MENU
Select main menu - Option 4, System Test
Enter your Installer code.
Select sensor walk test
The ZeroWire will chirp the siren and announce the
sensor name and the signal level of each sensor that
is triggered.
Hear the status of each sensor that has been tested.
Exits from System Test
Select main menu - Option 4, System Test.
Enter your Installer code.
Select siren test.
Press Mute to stop sirens (within 30 seconds).
Exit from the menu.
17