Setting The Date, Time And Location - Cisco MX200 Getting Started Manual

Cisco TelePresence Systems
GettinG started Guide
Table of contents Introduction
Web interface
Setting the date, time and location
When setting up your video conference system, you
should check that the date and time settings are correct.
Among other things this information is used to time stamp
messages transmitted to gatekeepers and other network
elements.
If you operate your system using the Touch controller, the
time is shown in the top right corner of the Touch controller
display; if you operate your system using a remote control,
the time and date is shown in the top right corner of the
main display.
Save the new value when you change a setting
Click ok to save the change, or cancel
without saving.
D14639.04 Video Systems Getting Started Guide (TC4.2) | 2011 JULY | © 2011 Cisco Systems, Inc. All rights reserved.
User interfaces
1. Go to the Configuration
Configuration.
Click on Time.
2. Select your preferred time format in the
drop down list.
3. Select your preferred date format in the
drop down list.
4. Select your time zone in the
5. Click on NetworkServices
Select Auto, Manual
to leave
If you select Manual,
enter the NTP server address in the input field.
If you select Off, you have to enter the time and date
manually using either the Touch controller
Settings > Administrator Settings > Date, Time &
Location) or the remote control and on‑screen menu
system (Home > Settings > Date and
1 NTP mode:
Auto: The time is regularly updated using an NTP server. The
NTP server address is automatically obtained from the
network (DHCP).
Manual: The time is regularly updated using an NTP server. You
must manually enter the NTP server address.
Off: You must set the time manually. The time will not be
updated automatically.
Configuration Configuration Appendices
tab and select Advanced
TimeFormat
DateFormat
Zone drop down list.
and then on NTP.
or Off in the Mode drop down list.
1
also click on the Address value and
(More >
Time).
29
www.cisco.com