Setting Date, Time And Location - Cisco MX200 Getting Started Manual

Cisco TelePresence Systems
GettinG started Guide
Table of contents Introduction
remote control and on-screen menu
Setting date, time and location
When setting up your video conference system, you
should check that the date and time settings are correct.
Among other things this information is used to time stamp
messages transmitted to gatekeepers and other network
elements.
The time and date is shown in the top right corner of the
main display.
Save the new value when you change a setting
• Drop down list selection: Navigate to the correct
value and press the OK ( ) key to save, or press
the left arrow key to leave without saving.
• Text entry in an input field: Enter the text, navigate
to Ok/Save to save the change, or navigate to
Cancel to leave without saving; then press
OK ( ) to confirm.
D14639.04 Video Systems Getting Started Guide (TC4.2) | 2011 JULY | © 2011 Cisco Systems, Inc. All rights reserved.
User interfaces Configuration Configuration
1. Go to Home > Settings > Date and
2. Select 24 hours or 12 hours (am/pm)
drop down list as you prefer.
3. Select day.month.year, month.day.year
in the Date format drop down list as you prefer.
4. Select your time zone in the Time zone
5. Select Auto, Manual or Off in the
list as you prefer. 1
If you select Manual, also enter the
in the corresponding input field.
If you select Off, also select the correct value for Day,
Month, Year and Time in the corresponding drop down
lists.
6. Press Home ( ) to exit.
NTP mode:
1
Auto: The time is regularly updated using an NTP server. The
NTP server address is automatically obtained from the
network (DHCP).
Manual: The time is regularly updated using an NTP server. You
must manually enter the NTP server address.
Off: You must set the time manually. The time will not be
updated automatically.
Appendices
Time.
in the Time format
or year.month.day
drop down list.
NTP mode drop down
NTP server address
24
www.cisco.com