Using The Remote Control And On-Screen Menu For System Configuration - Cisco MX200 Getting Started Manual

Cisco TelePresence Systems
GettinG started Guide
Table of contents Introduction
remote control and on-screen menu
Using the remote control and on-screen menu for system configuration
Waking up the system
If there is no menu on screen, press Home
remote control to show the menu.
If the system does not show a menu on screen:
• Make sure the monitor is connected and has been
switched on.
• Make sure the remote control has the batteries installed.
• Make sure the system is switched on.
If the system has just been switched on, wait a few minutes
to allow the system to start up.
If there is still no menu on screen, make sure the monitor
cable is connected to the basic video output connector. If in
doubt, see the Installation guide for your product.
D14639.04 Video Systems Getting Started Guide (TC4.2) | 2011 JULY | © 2011 Cisco Systems, Inc. All rights reserved.
User interfaces
( ) on the
Configuration Configuration Appendices
Remote control and
on-screen menu
21
www.cisco.com