Configuring H.323 And Sip - Cisco MX200 Getting Started Manual

Cisco TelePresence Systems
GettinG started Guide
Table of contents Introduction
touch controller
Configuring H.323 and SIP
To get online and ready to place and receive calls, your
system must be set up properly. Your system will use either
the H.323 protocol or the SIP protocol for video calls.
NOTE: Contact your system administrator, or service
provider, for information about the network settings.
For networks administered through Cisco TMS (Cisco
TelePresence Management Suite) your Cisco TMS
administrator will help you to get online.
D14639.04 Video Systems Getting Started Guide (TC4.2) | 2011 JULY | © 2011 Cisco Systems, Inc. All rights reserved.
User interfaces Configuration Configuration
H.323
If in doubt for any of the parameters below, contact your
system administrator or your service provider.
1. Tap More > Settings > Administrator settings > Network
Settings > H323 Settings
2. Enter the H323 number and H323 id
input fields.
3. If you want to enter the address of the H.323 gatekeeper
manually, tap Manual in the Gatekeeper discovery
section, and enter the Gatekeeper address
field. Otherwise tap Auto.
4. If the H.323 gatekeeper requires authentication
and you want your system to authenticate itself to
the gatekeeper, tap ON in the
section and enter the Login name
respective input fields. Otherwise, tap OFF.
5. Tap Save to save the changes, or
saving.
6. Tap Back twice to review the System Information page
and verify the H323 settings.
If you successfully registered to a Gatekeeper the
will show Registered in the H323 section.
7. Tap Exit to return to the home menu.
Appendices
SIP
If in doubt for any of the parameters below, contact your
system administrator or your service provider.
1. Tap More > Settings > Administrator settings > Network
Settings > SIP Settings
in their respective 2. Enter the SIP URI in the
3. Tap the preferred transport protocol in the
transport
try to connect using TLS, then TCP, and finally UDP.
in the input
4. Choose a
proxy types by tapping the ‑ or + signs. The default type
is Standard.
5. If you want to enter the SIP proxy address manually,
Authentication mode
tap Manual
and Password in the
Proxy address
to obtain the SIP proxy address automatically (DHCP),
Undo to leave without tap Auto.
6. If the SIP proxy server requires authentication you must
enter the
input fields to authenticate your system.
Status
7. Tap Save
saving.
8. Tap Back
and verify the SIP settings.
If you successfully registered to a SIP server the
will show
9. Tap Exit
URI input field.
Default
section. If you select Auto, the system will first
Proxy type. Step through the list of available
in the Proxy discovery section and enter the
in the input field. If you want the system
Login name and Password in the respective
to save the changes, or Undo to leave without
twice to review the System Information page
Status
Registered in the SIP section.
to return to the home menu.
www.cisco.com
18