Setting The Date, Time And Location - Cisco Codec C Series Getting Started Manual

Cisco TelePresence Video Systems
Contents

Setting the date, time and location

(When not set by a provisioning system)
When setting up your video conference system, you should
check that the date and time settings are correct. Among other
things this information is used to time stamp messages transmit-
ted to gatekeepers and other network elements.
If you operate your system using the Touch controller, the time
is shown in the top right corner of the Touch controller display;
if you operate your system using a remote control, the time
and date is shown in the top right corner of the main display.
If you are changing a value setting,
you have to always click save to confirm the change.
Back to task overview
D14639.12 Video Systems Getting Started Guide TC7.0, DECEMBER 2013.
Introduction User interfaces
1. Go to the Configuration
Open the
2. Select your preferred date format in the
down list.
3. Select your preferred time format in the
down list.
4. Select your time zone in the
5. Open the
6. Under the
Mode drop down list.*
a. If you select
the Address
b. If you select Off, you have to enter the time and date
manually using either the Touch controller
Settings > Administrator Settings > Date, Time &
Location) or the remote control and on-screen menu
(Home > Settings > Date and
* NTP mode:
Auto: The time is regularly updated using an NTP server. The NTP server
address is automatically obtained from the network (DHCP).
Manual: The time is regularly updated using an NTP server. You must
manually enter the NTP server address.
Off: You must set the time manually. The time is not updated automatically.
Confirguration Configuration
tab and select System Configuration.
Time settings from the left column.
DateFormat
TimeFormat
Zone drop down list.
NetworkServices settings from the left column
NTP section select Auto, Manual or Off
Manual, enter the NTP server address in
input field.
(More >
Time).
27
Appendices
drop
drop
in the
Copyright © 2010–2013 Cisco Systems, Inc. All rights reserved.
Getting Started Guide
Contacts