Configuring H.323 And Sip - Cisco MX200 Getting Started Manual

Cisco TelePresence Systems
GettinG started Guide
Table of contents Introduction
Web interface
Configuring H.323 and SIP
To get online and ready to place and receive calls, your
system must be set up properly. Your system will use either
the H.323 protocol or the SIP protocol for video calls.
NOTE: Contact your system administrator, or service
provider, for information about the network settings.
For networks administered through Cisco TMS (Cisco
TelePresence Management Suite) your Cisco TMS
administrator will help you to get online.
Save the new value when you change a setting
Click ok to save the change, or cancel
without saving.
D14639.04 Video Systems Getting Started Guide (TC4.2) | 2011 JULY | © 2011 Cisco Systems, Inc. All rights reserved.
User interfaces
H.323
If in doubt for any of the parameters below, contact your
system administrator or your service provider.
1. Go to the Configuration
Configuration.
Click on H323
2. Click on H323 Alias
in their respective input fields.
3. Click on Gatekeeper.
If you want the system to obtain the H.323 gatekeeper
address automatically, select
to leave
down list; if you want to enter the address manually,
select Manual.
If set to Manual
corresponding input field.
4. If the H.323 gatekeeper requires authentication and
you want your system to authenticate itself to the
gatekeeper, click on
Mode drop down list. Then enter the
Password in the corresponding input fields.
Otherwise, select
5. Go to the Diagnostics
to verify the H323 settings.
If you successfully registered to a SIP server the
will show Registered
Please check the
want to change the other H.323 settings.
Configuration Configuration Appendices
tab and select Advanced
and then on Profile 1.
and enter the ID and E164 number
Auto in the Discovery drop
enter the gatekeeper Address in the
Authentication and select On in the
LoginName and
Off in the Mode drop down list.
tab and select System Information
Status
in the H323 section.
Administrator guide for your product if you
SIP
If in doubt for any of the parameters below, contact your
system administrator or your service provider.
1. Go to the Configuration tab and select
Configuration.
Click on SIP and then on Profile 1.
2. Enter the SIP URI in the URI 1 input field, and optionally a
display name in the DisplayName input field.
3. Select the preferred transport protocol from the
DefaultTransport drop down list. If you select Auto, the
system will first try to connect using TLS, then TCP, and
finally UDP.
4. Select a proxy type in the Type drop down list. The
default type is Standard.
5. Click on Proxy 1.
If you want the system to obtain the SIP proxy address
automatically, select Auto in the Discovery
list; if you want to enter the address manually, select
Manual.
If you select Manual enter the proxy Address
corresponding input field.
6. If the SIP proxy requires authentication you must enter a
login name and password to authenticate your system.
Click Authentication 1 and enter the LoginName
Password in the corresponding input fields.
7. Go to the Diagnostics tab and select System Information
to verify the SIP settings.
If you successfully registered to a SIP server the
will show Registered in the SIP section.
Please check the Administrator guide for your product if you
want to change the other SIP settings.
28
Advanced
drop down
in the
and
Status
www.cisco.com