Date, Time And Location - Cisco MX series Getting Started Manual

Cisco TelePresence Video Systems

Introduction

Date, time and location

(When not set by a provisioning system)
We recommend you check that the date and time settings
are correct when you set up your video conference system.
The system uses this information for example to time stamp
messages transmitted to gatekeepers and other network
elements.
If you are changing a value setting,
you have to always click save to confirm the change.
D15318.02 Video Systems Getting Started Guide CE8.1, APRIL 2016.
User interfaces Web interface Web interface
1. Go to Setup
settings from the left column.
2. Select your preferred date format in the
down list.
3. Select your preferred time format in the
down list.
4. Select your time zone in the
5. Open the
6. Under the
Mode drop down list.*
a. If you select
the Address
b. If you select Off, you have to enter the time and date
manually using either the Touch controller (
> Administrator > Date, Time &
command line interface (xCommand Time DateTime
Set) .
7. To verify the time settings, go to
Open Time
* NTP mode:
Auto: The time is regularly updated using an NTP server. The NTP server
address is automatically obtained from the network (DHCP).
Manual: The time is regularly updated using an NTP server. You must
manually enter the NTP server address.
Off: You must set the time manually. The time is not updated automatically.
On-screen setup assistant
tab and select Configuration. Open the
DateFormat
TimeFormat
Zone drop down list.
NetworkServices settings from the left side bar.
NTP section select Auto, Manual or Off
Manual, enter the NTP server address in
input field.
Settings
Location) or on the
Setup and click Status.
status from the left side bar.
17
Touch
Time
drop
drop
in the
Copyright © 2016 Cisco Systems, Inc. All rights reserved.
Getting Started Guide
Appendices