Datalog Commands - Rigol DM3000 Series Programming Manual

RIGOL

Datalog Commands

The commands are used to set the datalog system parameters for instrument.
The commands mainly include:
:datalog

:datalog:configure:function

:datalog:configure:startmode

:datalog:configure:startmode:auto

:datalog:configure:startmode:extern

:datalog:configure:startmode:delaytime

:datalog:configure:stopmode?

:datalog:configure:stopmode:time

:datalog:configure:stopmode:number

:datalog:configure:rate

:datalog:run

:datalog:stop

:datalog:fetchdata

NOTE：DM3000 series Digital Multimeter that the version is or later than 03.03.00.03
.02. 00.01 supports the Datalog Commands.
2-76
Programming Guide for DM3000 Series
© 2008 RIGOL Technologies, Inc.