Auxiliary - ZyXEL Communications ZyWALL USG 300 User Manual

Unified security gateway

Hide thumbs Also See for ZyWALL USG 300:

Table of Contents

10.14.2 Auxiliary

Use the Auxiliary screen to configure the ZyWALL's auxiliary interface. Click

Network > Interface > Auxiliary to open it.

Figure 163 Network > Interface > Auxiliary

Each field is described in the table below.

Table 70 Network > Interface > Auxiliary

General Settings

Dialing Type

Initial String

ZyWALL USG 300 User's Guide

Select this to turn on the auxiliary dial up interface. The interface

does not dial out, however, unless it is part of a trunk and load-

balancing conditions are satisfied.

This field is read-only and displays the zone to which the auxiliary

interface belongs.

Enter a description of this interface. It is not used elsewhere. You can

use alphanumeric and

()+/:=?!*#@$_%-

up to 60 characters long.

Select the speed of the connection between the ZyWALL and external

Tone - select this if the telephone uses tone-based dialing.

Pulse - select this if the telephone uses pulse-based dialing.

Enter the AT command string to initialize the external modem.

the most common string, but you should check the manual for the

external modem for additional commands.

Chapter 10 Interfaces

characters, and it can be

Show Quick Links

Table of Contents