Configuring Ftp - ZyXEL Communications ZyWALL USG 300 User Manual

46.9.1 Configuring FTP

To change your ZyWALL's FTP settings, click System > FTP tab. The screen
appears as shown. Use this screen to specify from which zones FTP can be used to
access the ZyWALL. You can also specify from which IP addresses the access can
come.
Figure 524 System > FTP
The following table describes the labels in this screen.
Table 243 System > FTP
LABEL
Enable
TLS required
Server Port
Server
Certificate
Service
Control
#
Zone
Address
ZyWALL USG 300 User's Guide
DESCRIPTION
Select the check box to allow or disallow the computer with the IP
address that matches the IP address(es) in the Service Control table to
access the ZyWALL using this service.
Select the check box to use FTP over TLS (Transport Layer Security) to
encrypt communication.
This implements TLS as a security mechanism to secure FTP clients and/
or servers.
You may change the server port number for a service if needed, however
you must use the same port number in order to use that service for
remote management.
Select the certificate whose corresponding private key is to be used to
identify the ZyWALL for FTP connections. You must have certificates
already configured in the My Certificates screen (Click My Certificates
and see Chapter 43 on page 689
This specifies from which computers you can access which ZyWALL
zones.
This the index number of the service control rule.
The entry with a hyphen (-) instead of a number is the ZyWALL's (non-
configurable) default policy. The ZyWALL applies this to traffic that does
not match any other configured rule. It is not an editable rule. To apply
other behavior, configure a rule that traffic will match so the ZyWALL will
not have to use the default policy.
This is the zone on the ZyWALL the user is allowed or denied to access.
This is the object name of the IP address(es) with which the computer is
allowed or denied to access.
Chapter 46 System
for details).
763