Table of Contents
Advertisement
Symptom
The copy is too light.
The images on the copy are
skewed.
The copy is not made on paper
of the desired size.
Check
Is the density of the document too light?
Is copy density set at Lightest?
Is the document loaded correctly?
Is the document guide on the DADF at the
right position?
Is the paper loaded correctly in the tray?
Is the paper guide of tray 5 (bypass)
adjusted properly so that it touches the
paper?
Is the paper tray set properly?
Is the document glass or document cover
dirty?
Is the document a transparent material?
Is the document placed at the right
position?
Is the document guide of the DADF out of
position?
Is the Image Rotation feature set to On?
Has the document been
folded like the picture on
the right?
Is there anything
placed on the DADF?
Troubleshooting
Measure
Select a darker copy density setting.
Increase toner dispensing level if copy is
still light after adjusting the copy density.
•
5-2 Adjusting Copy Density (Lighter/
Darker)
•
8-3 Increasing the Toner Level
Load the document correctly.
•
3-2 Loading Documents
Load the document properly and ensure
that the guide touches the edge of the
loaded document.
•
Loading documents in the DADF
3-2 Loading Documents
Loaded the paper correctly.
•
2-3 Loading Paper
Adjust the paper guide so that it touches
the paper gently.
•
Loading paper in tray 5 (bypass) of
2-3 Loading Paper
Ensure that the paper tray is pushed in
completely.
•
2-3 Loading Paper
Clean the document glass or document
cover.
•
8-1 Cleaning the Copier
Place the document on the document
glass. Then place a sheet of white paper
over the document.
Load the document correctly.
•
3-2 Loading Documents
Load document correctly by adjusting the
document guide to touch the edge of it.
•
3-2 Loading Documents
Set Image Rotation feature to Off.
•
5-11 Rotating and Copying in
Different Directions (Image Rotation)
Flatten the document and reload it.
Remove it.
7-1 Troubleshooting
in
7
165
Advertisement
Table of Contents
