Panasonic DP-6000 Operating Instructions Manual page 12

When moving the machine, be sure to unplug
the power cord from the outlet. If the machine is
moved with the power cord connected, it can
cause damage to the cord which could result in
fire or electric shocks.
When moving the machine, do not tilt it more
than indicated below. If tilted excessively, the
machine may fall over and cause injuries.
Power requirements and earthing connection
Three power specifications are listed below. The
specifications that apply to your machine
depend on your machine configuration. Connect
the power plug only to a properly rated power
outlet. Otherwise, it can cause fire or electric
shocks. If in doubt, contact your local
authorized Panasonic service representative.
Rated voltage: 100 V
Rated frequency: 50/60 Hz
Rated voltage: 110 V
Rated frequency: 60 Hz
Rated voltage: 220 - 240 V
Rated frequency: 50/60 Hz
x
After the machine is installed, be sure to lock the
caster stoppers. An unlocked machine may fall
over or slide and cause injuries.
Other precautions
The machine is capable of operating normally
within the following recommended environmental
limits. The temperature range is 50°F-95°F,
humidity range is 15-85% (without condensation).
The humidity should be 47.5% or below at 95°F,
and 85% at 95°F or below.
○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○
Sudden temperature fluctuations can affect copy
quality. Rapid heating of a cold room can cause
condensation inside the machine, directly interfering
with image transfer.
○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○
Do not expose the machine to direct sunlight.
Exposure to direct sunlight can adversely affect
the machine's performance.
Never use multi-plug adaptors to plug multiple
power plugs in the same outlet. Be sure to
operate the machine on a sole-use
receptacle. Multiple connectors can cause
the outlet to overheat and cause fire.
Ensure that the plug connection is free of dust.
In a damp environment, a contaminated
connector can draw a non-negligible amount of
current that can generate heat and eventually
cause a fire over an extended period of time.
Always use the power cord provided with your
machine. When an extension power cord is
required, always use a properly rated cord. In
Japan, it is 125 V/15 A. In other countries, contact
your local authorized Panasonic service
representative. If you use a cord with an
unspecified current rating, the machine or plug may
emit smoke or become hot to the touch externally.
○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○
○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○