Multicast Setting - ZyXEL Communications VES1724-56 User Manual

24.3 Multicast Setting

Click Advanced Applications > Multicast > Multicast Setting link to display the screen as
shown. See
Figure 126 Advanced Application > Multicast > Multicast Setting
The following table describes the labels in this screen.
Table 91 Advanced Application > Multicast > Multicast Setting
LABEL
IGMP Action
Active
Enable MLD
Host Timeout
Leave Timeout Enter an IGMP leave timeout value (from 1 to 16,711,450) in seconds. This defines how
802.1p Priority Select a priority level (0-7) to which the Switch changes the priority in outgoing IGMP
VES1724-56 User's Guide
Section 24.1 on page 217
DESCRIPTION
Use these settings to configure multicast group membership discovery.
Select None to disable multicast group membership discovery on the Switch.
Select Snooping to enable IGMP/MLD snooping to forward group multicast traffic only to
ports that are members of that group.
Select Proxy to enable IGMP/MLD proxy to decrease subscriber's join/leave messages
forwarding in a group.
Enables Multicast Listener Discovery version one (MLD v1) and version two (MLD v2) on
the Switch. See Section 24.1.6 on page 218
Specify the time (from 1 to 16,711,450) in seconds that elapses before the Switch
removes an IGMP group membership entry if it does not receive report messages from the
port.
many seconds the Switch waits for an IGMP report before removing an IGMP snooping
membership entry when an IGMP leave message is received from a host.
control packets. Otherwise, select No-Change to not replace the priority.
for more information on multicasting.
for information about MLD.
Chapter 24 Multicast
221