Using The Display Control; Broadcast Mode - Sony IPELA PCS-XL55 Operating Instructions Manual

Using the Display Control

During a multipoint connection you can control the following operations.

Broadcast Mode

There are four broadcast modes, "Split" and "Voice Activate", and "Split
(fixed)" and the broadcast select mode.
You can set up "Split" and "Voice Activate" modes in "Broadcast Mode" of
the Multipoint setup menu.
You can select "Split (fixed)" and broadcast select modes in the Layout menu
during communication.
Split mode
This mode allows display of the pictures of the connected remote terminals and
the picture of the local terminal by splitting the monitor screen.
You can select "Six-screen Mosaic" or "Four-screen Mosaic" in "Split" of the
Multipoint setup menu.
The split windows A to B display the pictures of the remote terminals in the
connected sequence.
Four-split window
Picture A
Picture on the
local terminal
Notes
• When the six-split window is displayed, the system detects the terminal including the
loudest voice among all the terminals and displays the picture of that terminal in the
lower right window. The picture on the local terminal is then displayed in the window
where the picture of the detected terminal was displayed.
• If you switch the broadcast mode from "Split" to "Voice Activate" in which the
picture of a specified terminal is displayed in full screen during communication, the
location of Pictures A to B will be changed when "Split" mode is restored.
Picture B
Six-split window
Picture A Picture B
Using the Display Control
Picture on the
local terminal
183